Steven

Structure of Injection Mold A mold is made from various parts, including plates, pins, bushings, pillars, ejectors, and many other pieces of equipment that serve a number of purposes. In Figure 1, the locations of the basic items that comprise the…

             “Auxiliary Equipment” is considered any additional equipment required for assisting the primary equipment (molding machine) in producing the final production of the molded parts. It includes items such as granulators, mold temperature controllers, hopper…

Plastic Mold Building Tips I’m sure you’ll agree with me when I say: Building a perfect plastic mold is really complicated. Or, is it? Well, it turns out that finish this job may not be as hard as you’d have…

       All the effective technique of controlling the quality and the expense of an item is based greatly on the uniformity with the method employed to produce that item. Uniformity are only able to be accomplished by securely…

Plastic Mould Ejection Injection moulding compounds exhibit a certain amount of shrinkage，i.e., in a cooled condition, the volume is somewhat smaller than in a heated condition. If parts with accurate dimensions are needed, allowances must be made for this shrinkage…

  Mold surface treatment technology In addition to the reasonable cooperation of the steel  strength and toughness, its surface properties are critical to the work performance and service life of the mold. These surface properties refer to: wear resistance, corrosion…

Undercuts Modern molding practice dictates certain principles of design which should be observed if molded articles are to be produced successfully. Most elementary is the fact that the piece must be easily removed from the mold after it has been…